5 Ways to Stop your Expanding Foam Tape From Sticking

Introduction

Got a whole roll of expanding foam tape, but don’t really know what to do with it? Don’t worry! This article is going to show you all the ways that you can use your expanding foam tape without having it stick all over your hands and clothes.

Use a primer.

You should use a primer before applying your foam tape. A primer is a thin layer of paint used to prepare a surface for another coat of paint. Primers are used to seal the surface, prevent bleeding and give the surface a smooth finish which allows for better adhesion of the paint or foam tape. Some primers can also be used to make surfaces more porous so that they will absorb more paint or adhesive into them.

Use an oil-based primer when using latex-based foam tape (such as on drywall).
Use a latex-based primer when using acrylic-based foam tapes (such as on concrete).

Apply powder before foam tape.

You can also apply a thin coat of primer before you use foam tape. This will help the foam tape stick better to the glass and make it stronger, so it won’t peel off easily.

This is especially important if your window has small cracks in it that you can’t see, but which can cause problems with the application process. If there are any cracks or imperfections on your window, then they will prevent your tape from sticking as well as it should.

Try to use less of the foam.

If you’re using the foam tape to stick two things together, try using less of it. A good rule of thumb is to use a smaller piece than you think will be enough. You can always cut another piece if needed, but if you need to go back and remove some from where it isn’t necessary, it will take longer and be more difficult.

If you need to apply the foam tape on one side of something (like an electrical cord), consider applying less on both sides so that there is more flexibility for bending around curves or corners without causing damage to the adhesive layer.

Use heat to melt it, then grab with a tool.

Use a heat gun to melt the foam.
Grab the tape with a putty knife or other tool (make sure you have gloves and eye protection!)
Wash the tool with soap and water after removing it from your wall/ceiling/etc.

Be prepared and use gloves and protective gear when you work with foam adhesive.

Make sure to wear protective gear when applying foam adhesive. The following is a list of equipment you should use:

Gloves
Mask or respirator (depending on the type of foam tape you’re using)
Eye protection (sunglasses, goggles, etc.)
Long sleeves and long pants
Closed-toe shoes or boots with no metal studs on the soles

Sand the glued spots until they are smooth. This will prepare them for painting.

If you have a lot of glued spots, it may be hard to sand them all by hand. In this case, use an electric sander or a manual power tool that has a sanding attachment. There are many different types that you can use:

Sanding blocks
Low grit sandpaper (60-120)
High grit sandpaper (220-400)
Sanding spindle
Sanding disc or drum (these are also known as mouse pads)

There are many ways to remove foam adhesive that are chemical-free and easy to do, but keeping it from sticking in the first place is all about preparation.

Preparing the surface with a primer will help ensure a better bond between your object and the tape.
Using powder before applying foam helps create a stronger bond between your object and the tape.
Using less foam will result in less stuck-on residue when peeling off at a later date!
If you’re working with large quantities of adhesive, try heating it up before application or after with an iron or hot air gun (if using for craft projects). This should melt away any excess glue that might otherwise resist removal later on down the line!

Conclusion

We hope you found these tips helpful. If you have any other ideas for how to remove foam adhesive, please share them with us! We love hearing from our readers and learning new ways to make your home improvement projects even better.